Home/Support/Support Forum/Incorret ADC read from Xbee3 micropython

Incorret ADC read from Xbee3 micropython

0 votes
Hi,
i have a strange problem using the Xbee3 embedded micropython and ADC read.
I have the pin D0 configured as ADC with vref set to vcc.
If i read the acd value via transparent mode, i get a good value; if a make a read via micropython, i get a wrong value about 4 time greater than the good value..

I didn't find any solution.. the XBee3 have the last firmware and the problem appear with the pro and also standard version..

Some one have some clue??
asked Sep 18 in XBee3 DigiMesh by Teos81 New to the Community (0 points)

Please log in or register to answer this question.

...