Home/Support/Support Forum/Why End-Devices persist in the Routing Table of a Coordinator even those End-Devices are not connected any more?

Why End-Devices persist in the Routing Table of a Coordinator even those End-Devices are not connected any more?

0 votes
I have been experiencing the next behavior:

I have a Coordinator with two Routers and two End Devices, all of them are S2C series XBEE.

Using XCTU in Network Working Mode, I see the two devices connected to the Coordinator, but if I disconect one of the End Devices or Both, the still being showing as connected in the Network Graph, with a grey flag betwen them and the Coordinator.

Not the same as the Router, where If I disconnect one of both of them, the left to show in the Network Graph.

As further details, I can say, that in the link shown in the Network Graph shown between Routers and the Coordinator, it shows 255/255, but in the link shown between End-Devices and the Coordinator, it shows 255/0
asked Oct 3 in XBee3 ZigBee by Molas89 New to the Community (4 points)

Please log in or register to answer this question.

...