Home/Support/Support Forum/How to configure XBEE3 for digital line passing?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to configure XBEE3 for digital line passing?

0 votes
I'm using a Digi Xbee3 zigbee mesh kit to develop a simple wireless sensor.

For some reason I can't find configuration parameter for I/O line passing Input address. When I use terminal command "IA" I receive an error message from the XBee module.

Can anyone explain this to me?
asked Oct 23, 2019 in RF Solutions and XBee by prpkr New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Did you start with +++ and abide by the guard time? I'd start by talking to it with XTCU to ensure IA is a valid parameter for that module, then try other benign AT commands until you're sure of the syntax.

Good Luck
answered Apr 17, 2020 by smanganelli New to the Community (5 points)
...