Home/Support/Support Forum/Digimesh AG (Aggregator Support) not updating end device DH DL

Digimesh AG (Aggregator Support) not updating end device DH DL

0 votes
My coordinator and end devices are all XB9X-DM with FW 9007.

I am trying to have the aggregator/coordinator/master node broadcast it's address to the subnodes so they know where to respond.

From the coordinator serial console, I build an ATAG command frame with the coordinator's MAC as the parameter as follows;
7E 00 0C 08 01 41 47 00 13 A2 00 41 8E BC 77 B7

After sending the frame the console shows a Status OK response.

None of the end devices update their DH/DL values, nor do they transmit the Aggregate Addressing Update frame out the serial port.

I have tried setting all DH/DL to 0xFFFF, discrete addresses and default. I get no discernible change.

Is this a valid use of the AG command? Does the AG command work?
asked Oct 28, 2019 in DigiMesh Proprietary Mesh Networking by jrgert New to the Community (0 points)

Please log in or register to answer this question.

...