Home/Support/Support Forum/Infinite loop with Xbee3 - Freeze

Infinite loop with Xbee3 - Freeze

0 votes

By mistake, I programmed an infinite loop using the terminal with an XBee3 and I can not stop the program either with XCTU or with Pycharm.

What is the solution to regain control?

Thank you
asked Nov 1, 2019 in XBee3 ZigBee by Jean Philippe New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
You can try to issue a remote AT command to restore to defaults from another module.
answered Nov 13, 2019 by mvut Veteran of the Digi Community (14,297 points)
0 votes
Try to connect it with XCTU. Then format the filesystem under File System Manager
answered Feb 27, 2020 by Corné New to the Community (2 points)