Home/Support/Support Forum/Xbee Router Showing as End Device

Xbee Router Showing as End Device

0 votes
I have an issue where my Xbee devices are showing up as end devices when plugged into my custom PBCA. They show up as routers when plugged into the Grove dev board, but not when plugged into my board. I'm trying to narrow down what to troubleshoot so any advice is helpful.

The module that is plugged into my board shows up as an end device, but the communication strength just shows 255/?. I'm sure that's a clue pointing to something, I'm just now sure what.
asked Nov 5 in Multipoint Proprietary by dfj3404 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Are you setting any of the modules parameters on your board? Possibly the SM command?
answered 6 days ago by mvut Veteran of the Digi Community (11,362 points)
...