Home/Support/Support Forum/Would there be any time delay required to switch from command mode to data mode while using AT commands?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Would there be any time delay required to switch from command mode to data mode while using AT commands?

0 votes
asked Dec 12, 2019 in Other/Legacy by Bhuvana New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Once you exit command mode indicated by the "ok" after issuing the ATCN command, the Digi XBee module is ready to send and receive data.
answered Dec 12, 2019 by mvut Veteran of the Digi Community (12,302 points)
...