Home/Support/Support Forum/Home automation profile on Xbee S2C wire antenna module

Home automation profile on Xbee S2C wire antenna module

0 votes
I want to know how to configure Xbee S2C wire antenna module with HA (Home automation) profile via XCTU or any other way. Could you all please assist with details?
asked Dec 12, 2019 in RF Solutions and XBee by gsshewalkar New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Take a look at https://www.digi.com/support/knowledge-base/zigbee-home-automation
answered Dec 12, 2019 by mvut Veteran of the Digi Community (11,639 points)
Thanks mvut for the kind response.
It's done. Function set for firmware is ZIGBEE TH REG. I hope that's correct.
0 votes
Link shared by mvut should help you connect Digi S2C module with HA network. However, since is module is mere "HA Ready", you have to connect some MCU to handle all HA specific commands and queries.
answered Dec 13, 2019 by asgm Veteran of the Digi Community (1,495 points)
Okay. Yes I have connected xbee to host MCU and I want my xbee to communicate with external non digi zigbee device.

Please correct me but if other device (which is coordinator) is already in HA network, then pairing process between xbee and external device would automatically happen or what are the steps from xbee side to accomplish the pairing and join the network?
...