Home/Support/Support Forum/Home automation profile on Xbee S2C wire antenna module
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Home automation profile on Xbee S2C wire antenna module

0 votes
I want to know how to configure Xbee S2C wire antenna module with HA (Home automation) profile via XCTU or any other way. Could you all please assist with details?
asked Dec 12, 2019 in RF Solutions and XBee by gsshewalkar New to the Community (1 point)

Please log in or register to answer this question.

3 Answers

0 votes
 
Best answer
Take a look at https://www.digi.com/support/knowledge-base/zigbee-home-automation
answered Dec 12, 2019 by mvut Veteran of the Digi Community (15,354 points)
selected Feb 24, 2020 by gsshewalkar
Thanks mvut for the kind response.
It's done. Function set for firmware is ZIGBEE TH REG. I hope that's correct.
commented Dec 13, 2019 by gsshewalkar New to the Community (1 point)
0 votes
Link shared by mvut should help you connect Digi S2C module with HA network. However, since is module is mere "HA Ready", you have to connect some MCU to handle all HA specific commands and queries.
answered Dec 13, 2019 by asgm Veteran of the Digi Community (1,499 points)
Okay. Yes I have connected xbee to host MCU and I want my xbee to communicate with external non digi zigbee device.

Please correct me but if other device (which is coordinator) is already in HA network, then pairing process between xbee and external device would automatically happen or what are the steps from xbee side to accomplish the pairing and join the network?
commented Dec 13, 2019 by gsshewalkar New to the Community (1 point)
0 votes
I configured my Xbee S2C antenna module with Home automation profile via XCTU with the solution provided on the link on earlier comment.
answered Jan 23, 2020 by Lugubrious New to the Community (1 point)
edited Feb 4, 2020 by Lugubrious
...