Home/Support/Support Forum/Debug mode in Micropython for xbee 3 Zigbee

Debug mode in Micropython for xbee 3 Zigbee

0 votes
I have Micropython running with a small network of Xbee 3 ZigBee modules in PyCharm.
That is working well in Run mode.

When I select Debug (Menu Run, then Debug) mode, it is doesn't show a Debug option. When started via that Debug mode, it runs as usual without stopping at breakpoints. For a non-MicroPython project, PyCharm offers a Debug mode option, and does stop at breakpoints, etc.

(1) Does Micropython for Xbee 3 ZigBee support a debug mode with breakpoints, etc?
(2) If so, where is the related documentation?

Thanks,
Dave
asked Dec 23, 2019 in RF Solutions and XBee by aadgi New to the Community (3 points)

Please log in or register to answer this question.

2 Answers

0 votes
The radio does not support a debug output. Not from PyCharm. You wold need to put print statements in at different points and then cut and past the code via the REBL interface in XCTU.
answered Dec 23, 2019 by mvut Veteran of the Digi Community (14,715 points)
0 votes
Ok, thanks for the reply.
answered Dec 26, 2019 by aadgi New to the Community (3 points)
...