Home/Support/Support Forum/Connect ME does not connect to the network
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Connect ME does not connect to the network

0 votes
Hi. I am having the same problem in several modules.
All are Connect ME 4MB -S modules. After working correctly for several days or weeks, they stop working.
The problem is that they do not connect to the network. The modules are connected to the network through switches. The switch has LEDs that indicate when a device has been connected, but when I connect the Connect ME module the switch LED does not turn on.

I can also observe that when I connect power to the Connect ME module, the green LED flashes 3 times, then the orange LED flashes 2 times and finally the green LED flashes again a number of times. Then the two LEDs remain off.

I have tried a factory reset by setting pin 20 (/ INIT) to GND for more than 30 seconds but everything remains the same.
asked Jan 10 in Plug N' Play by raymirabel New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
If your modules are under warranty, please open a support ticket and request RMA. If this happens on multiple modules, please also request a Failure Analysis.
answered Jan 10 by LeonidM Veteran of the Digi Community (3,212 points)
...