Home/Support/Support Forum/Error in founding device s2d series
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Error in founding device s2d series

0 votes
i am given the command to XB24DZ7UIS-004 (S2D Family) for creating the star network using XCTU software.
i am setting parameters using AT command mode
1)ATCE=0 (i want this module as end device)
2)ATSC=7FFF(by default)
3)ATNI=Slave1(name of the device)
5)ATSM=4(Cyclick sleep mode)
All command set then remove the module from USB to TTL converter and again try to connect/search the module but its show error device not fount.
asked Feb 6, 2020 in Device Manager by rajashree_kadam New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes

Do you have a Coordinator set up for your base node? This product is a Zigbee mesh based product. In order to establish a network and communicate, you must have one as an always on Coordinator.

Digi Support
answered Feb 7, 2020 by mvut Veteran of the Digi Community (15,408 points)