Home/Support/Support Forum/[S2C]ATMY is read only and the tutorials I'm using is asking me change ATMY value.

[S2C]ATMY is read only and the tutorials I'm using is asking me change ATMY value.

0 votes
MY parameter is 0 for coordinator node.

The tutorials I'm using are:
https://spin.atomicobject.com/2016/07/18/xbee-tutorial/

and

https://www.youtube.com/watch?v=vKVNmA8C6m8

I want both XBees to communicate.

Could anyone also suggest better resources and tutorials?
asked Feb 21 in IEEE 802.15.4 by faultyAnarchy New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Faulty,

The MY command is only changeable on the 802.15.4 firmware versions. All of the others use a 64 bit address function which uses the Serial number High and Low for the Source address and the DL and DH functions for the destination address.

Eric
Digi Support
answered Feb 21 by mvut Veteran of the Digi Community (13,085 points)
...