Home/Support/Support Forum/LED and Button

LED and Button

0 votes
I have a couple of XBee s2c modules with a ZigBee TH firmware. I have configured the first module as a Coordinator in API 2 mode and the second module as a router in AT mode. I have configured the DL of the first module with the low part of the router device and vice versa. I have connected the coordinator to with a LED by enabling pin 19 as a Digital Out Low. I connected the button to router by enabling pin 19 as Digital Input. But I am unable to light up the LED.

Are there any other configurations I need to make. Please help me

Thank you
asked Mar 4, 2020 in RF Solutions and XBee by Aravind New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes

The Zigbee code does not support DIO line passing. You need to use the 802.15.4 code for that kind of function.

Digi Support
answered Mar 9, 2020 by mvut Veteran of the Digi Community (15,110 points)