Home/Support/Support Forum/LED and Button

LED and Button

0 votes
I have a couple of XBee s2c modules with a ZigBee TH firmware. I have configured the first module as a Coordinator in API 2 mode and the second module as a router in AT mode. I have configured the DL of the first module with the low part of the router device and vice versa. I have connected the coordinator to with a LED by enabling pin 19 as a Digital Out Low. I connected the button to router by enabling pin 19 as Digital Input. But I am unable to light up the LED.

Are there any other configurations I need to make. Please help me

Thank you
asked Mar 4 in RF Solutions and XBee by Aravind New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Aravid,

The Zigbee code does not support DIO line passing. You need to use the 802.15.4 code for that kind of function.

Digi Support
answered Mar 9 by mvut Veteran of the Digi Community (12,001 points)
...