Home/Support/Support Forum/Xbee3 micropython GPIO interrupt

Xbee3 micropython GPIO interrupt

0 votes
Hi,

Will have Xbee3 in micropython implemented interrupt on GPIO? I need continuously calculate the raising edge on GPIO. Polling is unuseable.
asked Mar 11 in XBee3 ZigBee by viteka32 New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
Viteka,

Have you looked at what is offered in the examples located https://www.digi.com/support/productdetail?pid=5674&type=documentation

Digi Support
answered Mar 12 by mvut Veteran of the Digi Community (11,963 points)
0 votes
MVUT,

yes, I looked, but GPIO interrupt doesn't exist.

Therefore, I ask if there is any possibility that the GPIO interrupt be added to the new version of micropython. In the examples was only a pooling method. Micropython for xbee3 is very limited.
answered Mar 13 by viteka32 New to the Community (1 point)
...