Home/Support/Support Forum/Sample debug FW works fine, release not
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Sample debug FW works fine, release not

0 votes
Referring to this discussion before:
I have now successfully compiled sample project, modified it and it works as my exception on the debug mode in JTAG DC-ME-01-JT module.
If I now compile release FW of that project according to help "deploying a NET+OS application to a Device" and upload both rom.bin and image.bin found on release folder using ftp transfer in binary mode, my target module DC-ME-01T-C doesn't boot in my FW but runs into a recovery boot. I can recover it back with TFTP procedure.
I even tried the same release FW upload with FTP to my JTAG module inspecting in the meanwhile serial output of the JTAG module which tells checksum correct after upload.

What am I doing wrong?
asked May 5, 2020 in Embedded Devices by phy123 New to the Community (6 points)

Please log in or register to answer this question.

1 Answer

0 votes
Best answer
I found similar topics


were release FW wasn't not upgraded correctly.

I found solution which requires rom.bin and image.bin to be uploaded separately via FTP; rom.bin first, then let the device boot up and secondly upload image.bin. Then the release files are updated correctly and the device boots up.

My devices have originally 6.x and my release files are in
answered May 6, 2020 by phy123 New to the Community (6 points)
selected May 6, 2020 by phy123