Home/Support/Support Forum/Is there a way to prefix the datastream from router to coordinator?

Is there a way to prefix the datastream from router to coordinator?

0 votes
Sorry, I am not sure if I am in the correct category. Also, I am a beginner so be kind :-) I have two Xbee-Pro 900HP radios. A router and a coordinator. The router has a GPS connected to it. The GPS coordinates xmit over to the Coordinator just fine. My question, is there a way to prefix the GPS datastream from the the Router to the Coordinator with the ID (or any unique identifier)? Eventually I would like to add additional Xbees with additional sensors. I need a way to identify what Router the data is coming from on the Coordinator. Any help would be greatly appreciated.
asked May 11 in XCTU by wrwygal New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Wrwygal,

The only way to do that out side of the GPS is to enable API mode on the Coordinator (receiving side). Then the output will be in our API frames.

Digi Support
answered May 11 by mvut Veteran of the Digi Community (12,834 points)
...