Home/Support/Support Forum/Receiving Events from Aqara sensors

Receiving Events from Aqara sensors

0 votes
I have set-up an XBee S2C module as a coordinator and set the parameters to connect to Home Automation end-units. When using the Scan option of the XCTU, my Aqara sensors appear OK in the connected devices. But I am not able to receive any Event from the sensors (e.g. closing and opening a Aqara magnetic switch). I am using the XCTU Consoles Working Mode to check for any
Explicit Rx Indicator - but nothing is received.
asked Jun 1, 2020 in RF Solutions and XBee by Feuerstein New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
You may need to write some code to issue the proper API frames to tell the Sensor to send the data. I would suggest starting with pulling for active end points.
answered Jun 1, 2020 by mvut Veteran of the Digi Community (13,680 points)
...