Home/Support/Support Forum/Analog/digitial ground on XBee SX 868
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Analog/digitial ground on XBee SX 868

0 votes

does anybody know if there is a seperate analog ground PIN on the XBee SX 868 module? Or are these two grounds (digital and analog) tight together on the same PINs?

What is the total accuracy of the 4 ADCs?
I measure a 1.000 Ohm resistor with results between 995 and 1.005 Ohm powered with a Li-Ion battery to get a smooth voltage at the ADC PIN. My level shifter is connected to ON/SLEEP with a 4.900 resistor in series to use the internal 1.25V reference voltage.
Is there any low pass filter active on the XBee SX 868 µC?
asked Jun 1, 2020 in DigiMesh Proprietary Mesh Networking by marius_xbee New to the Community (9 points)

Please log in or register to answer this question.

2 Answers

0 votes
Best answer
There is only one ground on that product and it is used for everything.

It is a 10 bit ADC from 0 to 1.25V.

No, there is no external low pass filter used on the ADC lines.
answered Jun 2, 2020 by mvut Veteran of the Digi Community (15,515 points)
selected Jun 2, 2020 by marius_xbee
0 votes
this is really good VidMateTeaTVShareit
answered Jun 4, 2020 by alfred0809 New to the Community (2 points)
edited Jun 28, 2020 by alfred0809