in my XBee network i need to route data: end device -> 1 or 2 repeater -> coordinator. Therefore, am i right, that the only topology for that is DigiMesh on the XBee SX 868?
The end device is battery powered, so it sleeps most of the time. When i use DigiMesh, isn't it possible to use asynchronous sleep mode, only synchronous sleep mode on the end device?
My opinion for that was an asynchronous cyclic sleep end device -> repeater (always on) -> coordinator (always on), isn't it possible?
Only found te following topic but the answer wasn't very clear for my questions.