I have scoured through the S3B Programmable's datasheet quite a bit (280 pages of it) and feel that it's pretty straight forward, but one thing I can't quite wrap my head around just yet is how the device is configured when considering the GPIO lines run "in parallel" with the stock processor on the radio.
The manual says the UART on the stock processor is intercepted by the Freescale, and that the Freescale provides a separate UART to the one exposed to the user on the chip (pins 2 and 3) to channel communication through itself instead. Got it.
How do we handle other GPIO since it is "in parallel?" Specifically:
1.) How does configuring the DIO with pull-ups and pull-downs come into play now when using XCTU? Do I "disable" them and assign the 40k pull-up like the manual advises? Do I need to do anything on the Freescale side to ensure the Freescale board disables/pinups these GPIO pins as well, or does doing it through XCTU ensure it is accounted for on the Freescale?
2.) Do we basically need to become familiar with the MC9S08QE32 datasheet in its entirety, or is the point of the SDK to completely abstract that aspect away from the developer?
3.) Are there any examples projects outside the SDK (or maybe one that I missed within the SDK) that show us how to sample IO, send it out, but also control outputs to devices based on sensor inputs and utilize the Freescale as a small controller? Presumably that's part of the added value here since the regular units can use IC and IR already to send in their DIO changes.