Home/Support/Support Forum/UART interrupt in Micropython mode

UART interrupt in Micropython mode

0 votes
We are working on Digi xbee 3 micro module and using firmware version '300A'
and we are working on configuration related to Xbee module and tried to configure the UART pin (especially UART input pin 4) as Interrupt mode(to check weather Xbee received particular string) in micropython mode but we did not got any resource for this so can you guide us with is matter.
asked Sep 21, 2020 in RF Solutions and XBee by ANOM New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
You are not able to use the Data In or Out lines for this function as they are used for the RBEL interface. You would need to use one of the other DIO lines for this purpose.
answered Sep 21, 2020 by mvut Veteran of the Digi Community (15,323 points)