Home/Support/Support Forum/AT command V+ doesnt work

AT command V+ doesnt work

0 votes

i'm trying to use AT V+ on a xbee3 digimesh 2.4 module to get/set the voltage supply threshold but always get an ERROR.

Firmware is 300B, xbee3 model XB3-24

Any ideas?
asked Oct 7, 2020 in XBee3 DigiMesh by aschroeder New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Best answer
That is because the command is invalid. That is to say, per the manual, there is No V+ command for this product.

answered Oct 7, 2020 by mvut Veteran of the Digi Community (14,881 points)
selected Oct 8, 2020 by aschroeder
Ah, sorry, my mistake