I have a Digi trasnport WR44 Vdsl model that we did a factory reset to.
It will no allow logins via the webui on 192.168.1.1.
The Serial port was open at 115.2 8N1 with Xon/Xoff hand shaking and I created a user 1 username, user 1 password password user 1 access 0.
The username account cannot ftp in.
I created another account with access 0 and it CAN login via ftp but not via the webui.
I can ssh to the router, ftp to the router, serial port to the router but cannot get int the webUI. In fact, the attempts don't show up in the event log either.
How can I proceed to revive this unit?
I used and old config consisting of a config.da0, pwd.da0 and a fw.txt. Copied those over and was able to get into the router.
It appears to work be REFUSES to initiate IPSec tunnels. No matter what I do, it wont' initiate tunnels.
Also, the GPRS cannot bring up a PPP1 connection with any FW 126.96.36.199 or above.
Also, running 188.8.131.52 has the event log full of this:
20:40:18, 07 Oct 2020,Certificate Code Error
Lib: SSL routines
Reason: sslv3 alert certificate unknown
So, a couple of things:
1. How do I get rid of those ssl3 errors in the event log?
2. How do I troubleshoot the IPSec. The router refuses to bring a tunnel up, it just won't initial. IPSec is checked int eh PPP1 setup.
I can ping yahoo and hk.pool.ntp.org from the router so the ppp1 interface is up..
Model: TransPort WR44v2
Part Number: WR44v2-U8P1-DE2-XX
Ethernet 0 MAC Address: 00:04:2D:04:79:34
Firmware Version: 184.108.40.206 (Dec 13 2018 12:12:39)
SBIOS Version: 7.66u
Build Version: LW
HW Version: 2202a
Mobile Module: GOBI UMTS