Home/Support/Support Forum/Scan giving error with XBee 3.0 in XCTU

Scan giving error with XBee 3.0 in XCTU

0 votes
I'm using an XBee 3.0 with firmware 100B (ZigBee 3.0 TH). I first set the module to API (No Escapes). All other parameters are at their defaults. Then press the network mode button. The module appears in the window.

After pressing the scan button, I get an error dialog:

Error discovering neighbors of xxx
Cannot find the local device xxx address
Remove it from the modules list on the left and add it again

The "xxx" in the dialog matches the MAC of the module.

Removing and adding it back results in the same error.

Any suggestiongs?

Thanks!
asked Oct 9, 2020 in RF Solutions and XBee by HeliGuy2000 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Make sure you are enabling API mode via the configuration screen and that module is connected to the PC via it's UART.
answered Oct 9, 2020 by mvut Veteran of the Digi Community (13,684 points)
...