Home/Support/Support Forum/Return ConnectCore6UL to factory state
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Return ConnectCore6UL to factory state

0 votes
I am developing factory-programming for products containing ConnectCore6UL 256-256-W-BT modules. The devices I have contain custom (product) firmware.

I would like to return the devices to the "factory" state, as shipped from Digi.
I do not have JTAG available - only SD and UART.
I'm hoping that perhaps there's a pre-built SD card image that I can download and use to reset the internal flash to stock state - which I assume wuuld be that just u-Boot is loaded on to the module?
asked Oct 21, 2020 in Linux by IanJ New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

–1 vote
You should be able to do it by following the instructions on programming the firmware.
https://www.digi.com/resources/documentation/digidocs/embedded/dey/3.0/cc6ul/yocto-gs_t_program-fw.html
answered Oct 21, 2020 by Campbell Veteran of the Digi Community (829 points)
No, this is almost the opposite of what I want to acheive -- I want to get back to the no-Linux and orginal U-Boot-only statue.
...