Home/Support/Support Forum/Point to Multipoint

Point to Multipoint

0 votes
I have 3 arduinos. one of them should send signal the other two arduino but i should not use broadcast mode. I am using xbees in AT mode. How can i communicate with each other at unicast mode?I know I should change DL DH parameter. Should i use AT commands to do that? Is there any trick to do easy way? I cannot trust reliability of AT commands.
asked Nov 9, 2020 in IEEE 802.15.4 by malt New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Yes you would need to enter command mode, change the DL/DH values and Exit command mode. Then send the data.

However, most arduino libraries that exits for the XBee use API mode instead. This keeps you from having to change the value via AT command mode.
answered Nov 9, 2020 by mvut Veteran of the Digi Community (15,112 points)