Home/Support/Support Forum/XBee S2C - Explicit Transmit using 64-bit address only

XBee S2C - Explicit Transmit using 64-bit address only

0 votes
Hi,

I'm attempting to send a uni-cast message from a coordinator to an end-node in API mode using an explicit addressing command frame.

If I set the correct 64-bit address and leave the 16-bit address as '0xFFFE', which I'm led to believe from the manual should work, I keep getting the response '7E00078B0FFFFD00240144'. The delivery status 0x24 signifies that the address was not found.

What could be causing the issue?
asked Nov 10, 2020 in RF Solutions and XBee by mPul New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
sound like the device is not on the same network.
answered Nov 10, 2020 by mvut Veteran of the Digi Community (14,297 points)
0 votes
If you do a scan (using the AT command ND, or the api framed equivalent) do you see the device you are trying to talk to?

Are you using the newer Transmit Request - 0x10 or older 64-bit Transmit Request - 0x00 ?

I use S1 XBees so I am stuck with using the older command set
answered Nov 23, 2020 by plater New to the Community (22 points)
...