Home/Support/Support Forum/Xbee3 goes to sleep even with Sleep set to 0?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Xbee3 goes to sleep even with Sleep set to 0?

0 votes
I have a batch of new (to me) Xbee3 standard pinout modules. They come as Zigbee so I reflash them to 802.15.4

So here is the issue: The 'sleep' pin in my design floats. I have not had a problem with this in the older S2Cs and even S1s but in some of my Xbee3s, it seems that even though sleep=0 OFF, that the pin floating might be putting it to sleep?

After a certain amount of time, about 10-15 minutes, the Xbee3 will just quit talking. It does not receive broadcast packets, nor does it respond to directed MAC messages. A power cycle clears this but it comes back.

If I go in and set the sleep pins to DISABLE, then I don't see this.

So the question is, is this a known issue?
asked Dec 8, 2020 in Other/Legacy by Martan3d New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
This is something that is better addressed via an email to tech.support@digi.com instead of a Forum post. When you send the email, please make sure to indicate which firmware version you are working with along with any specific settings and or pins used.
answered Dec 8, 2020 by mvut Veteran of the Digi Community (14,874 points)
...