Home/Support/Support Forum/how to unjoin end device from coordinator

how to unjoin end device from coordinator

0 votes
Hi
I set xbee3 module as ZHA.
and some end device(light switch) join a network.

this is a 64 bit address of end device.(000d6f000c1365bd)

and I tried to unjoin a device from coordinator using AT Command(Register Joining Device, 0x24) like this : 7e000d2401000d6f000c1365bd16bc004b

but, xbee3(coordinator) response like this : 7e0003a401b1a9
start delimiter : 7E
length : 00 03
frame type : A4 (Register Joining Device Status)
frame id : 01
register status : B1 (Address not found in the key table)
checksum : A9

my question is how to unjoin specific end device from coordinator.
(except AT Command, 'NR0')
asked Dec 16, 2020 in XBee3 ZigBee by gustcool2 New to the Community (4 points)

Please log in or register to answer this question.

2 Answers

0 votes
The ATNR0 command is how you do it. You can try the &X or you can look in the ZDO function to find one that will do the Job.
answered Dec 17, 2020 by mvut Veteran of the Digi Community (15,354 points)
I'm a begginer.
so I don't understand well. Could you please explain in more detail?
On the XBee, the NR command is what is called a Network Reset.  It can be done using a 0 (Local device) or with a 1 (Global).

When issued, the radio will either disassociated and try to re-join or will tell all nodes to disassociate and try to re-join.
0 votes
Yes, all this can be turned off, but there are many nuances to consider! But all this will be checked in the process of implementation, so I will not give an answer right away!
answered Dec 30, 2020 by liemmayer New to the Community (8 points)
...