I have XBP9B-DMST-002 900Mhz modules which has Digi Mesh 200k firmware on it. I was trying to put 10k firmware on this. (i believe hardware is essentially the same)
DMST tab does not have any other option than 200k, and When i choose XBP9b DPST 10k as product family it throws following error.
Error Updating Radio module
- Checking for bootloader updates... [OK]
- Getting device information... [OK]
- Entering programming mode... [ERROR]
Could not enter programming mode. > Could not reset the module.
Is there any way at all to program these modules for 10k data rate ?