I have the following setup:
- Arduino expansion board (has Arduino Leonardo Chip) = https://www.dfrobot.com/product-1148.html
- Grove Base Shield = https://www.seeedstudio.com/Base-Shield-V2.html
- Grove Bee Socket = https://wiki.seeedstudio.com/Grove-Bee_Socket/
- Digi XBee 3 PRO (or normal one), 2.4 Ghz Zigbee 3.0, PCB Ant, TH MT - I do not know if mine is pro or not. The numbers on it are 1948(at the top), 94V-0(at below of it). I cannot look the other side of the chip, because it is integrated with Grove Bee Socket.
Xbee is connected to the Serial Port of the base shield.
I downloaded the XCTU, but it was not able to discover any module. Only once it discovered a module but then could not find any firmware. Then when I rerun the discovery, I got nothing. Both tried it on Windows and Linux.
What should I do to debug? Is my setup alright to program this module?