Home/Support/Support Forum/join a network

join a network

0 votes
I want the digi SC2 to connect to an existing RF network.

The digi xbee3 sc2 is connected through a esp32 and connects through XCTU just fine.

objective: Join a existing Zigbee network

1) set digi sc2 xbee to default
set CE=0
set ID=0
set AP=1
write
switch to networking mode
scan the radio network

error
error discovering neighbors of 0013!20041C195D0
can not find the local device (same number) address
Remove it from the radio module list on the left and add it again
(retrying this does not help)
The number is the MAC of the digi module)

Question: Steps to connect to an existing network as an router
asked Feb 15 in XBee3 ZigBee by RonGroen New to the Community (3 points)

Please log in or register to answer this question.

2 Answers

0 votes
The Digi XBee 3 and Digi XBee S2C are different products. They are not the same.

You need to set the ZS parameter to the proper value for the XBee to connect to a 3rd party network or device.
answered Feb 15 by mvut Veteran of the Digi Community (14,666 points)
0 votes
thank you for your answer.
with I ZS=2 I found the Controller on the network once.
but I did not know what to do next.

Can you give a link to sample documentation of this subject?

Regards
answered Feb 16 by RonGroen New to the Community (3 points)
...