Home/Support/Support Forum/Sending API frame to control light
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Sending API frame to control light

–1 vote
I have the xbee3 module connect to light in the Zigbee network and I am trying to send a frame to change the status of the light, I determined the des. address and the frame type "0x11" and in the Data payload I am putting On/off.
In the response status I found "success" but the status of the light it is not changing.
What can be the mistake here ?
there are many documentations of DIGI but it is soo long.
Thanks for help
asked Apr 5, 2021 in Other/Legacy by Mohamad-Badr New to the Community (5 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to start with querying the 3rd party device to find out what it's active end points it supports. You can then use the Zigbee.org specifications for that device to find out what the correct ZDO (Zigbee device object) Endpoint and Cluster ID as well as the command you need to put into the API Explicit frame to do what you want.
answered Apr 5, 2021 by mvut Veteran of the Digi Community (15,408 points)
Thank you that was useful