Home/Support/Support Forum/Want not to operate an orphan scan of zigbee end device

Want not to operate an orphan scan of zigbee end device

0 votes
Hello,

I have some questions

I'm using one coordinator and 8 end-devices (Zigbee) for monitoring system.

When leaving work, I have to turn off the power of coordinator (it must be done because of safety).
Then, end-devices which use battery keep awake and scan their parent, so batteries are gone too fast.

1) Is there any method to prevent Zigbee end-device which is loosing parent from waking up?
2) Could I solve that problem in 802.15.4 Firmware?

If there is someone who can solve this problem, please let me know. Thanks.

AT Parameter (sleep) such as :
- SP : C8 (2 sec)
- SN : D2F0
- SM : [4] Cyclic sleep
- ST : 4E20 (20 sec)
asked Apr 6, 2021 in RF Solutions and XBee by Jeon Youngmin New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
For your network, it would be far better to switch to the 802.15.4 code on all of the modules.
answered Apr 8, 2021 by mvut Veteran of the Digi Community (14,881 points)
...