Home/Support/Support Forum/XBEE SX Radio Module Firmware update

XBEE SX Radio Module Firmware update

0 votes
Hello,
I would like to upgrade the Radio module (XBEE SX) firmware that is soldered on our controller board. I have access to CTS,RTS,DI,DOUT,GND,VDD signals. I have used XBIB-U-SS kit(without radio) to extend all the above mentioned signals to Our prototype. And then ran X-CTU to read all parameters, X-CTU is able to detect Radio, and communicate OK, but when I tried to upgrade the firmware it got a issue where it can't be able to enter into program mode. you can check the log below. Please let me know if I need to extend the RESET signal, and the connection details.

Also please let me know if there is other way to upgrade the Firmware.


- Checking for bootloader updates... [OK]
- Getting device information... [OK]
- Entering programming mode... [ERROR]
Could not enter programming mode. > Could not reset the module.
asked Apr 9, 2021 in DigiMesh Proprietary Mesh Networking by sailurao New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to add DTR to these lines. Have you tried using the OTA update option?
answered Apr 12, 2021 by mvut Veteran of the Digi Community (15,111 points)
...