Home/Support/Support Forum/Coordinator in Transparent mode receives its own data

Coordinator in Transparent mode receives its own data

0 votes
I have a quick question which I'm unable to find documentation on in a
timely manner.

The XBP24C (4061) is set to Coordinator mode (CE=1) and API mode is set
to Transparent mode (AP=0). Whenever I send packet / data out (TX pin)
(testing using embedded console in XCTU) the data are echoed back to RX
ttl pin.

Is this standard behavior in such configuration? I feel like this is

Is there a way to change this behavior (do not echo TX data to RX?)?

asked May 17, 2021 in ZigBee PRO Featureset (and legacy ZNet 2.5) by marcel22 New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Best answer

Probably the DH and DL values on this modules are set to 0x00 values. This is alias address of Coordinator. So basically Coordinator is transmitting data to itself right now.

Please change these values to address of destination radio and you will not see this echo anymore.

Digi Technical Support
answered May 17, 2021 by mathur Veteran of the Digi Community (289 points)
selected May 18, 2021 by marcel22