Home/Support/Support Forum/Help needed in using WIT2450 interfacing to computer through USB

Help needed in using WIT2450 interfacing to computer through USB

0 votes
Hi,

I m using WIT2450 module for my project work.
My project is to transfer the data processed by the main base WIT to remote which is connected to the USB port through a cable.
I ve configured the WIT2450 in three wire operation mode as mentioned and for baud rate 38400.
But the CFG bar is left unconnected.
Now i open the hyper terminal and set the baud to 38400, and as in i type the escape sequence i.e :wit2410 i don't get any response from the module, is there anything else i should do or please help me out .
The settings all related to commands are in default.
And i m using the WIT which is configured as base, to be connected the computer.
If still more details needed i can send the interface diagram also.
Pls help me
asked Jan 27, 2010 in XStream by kiranpreddy05 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I don't think you have reached the correct company. That is manufactured by someone else.
answered May 5, 2014 by mvut Veteran of the Digi Community (11,300 points)
...