Home/Support/Support Forum/How to configure S6B for peer-to-peer

How to configure S6B for peer-to-peer

0 votes
I have searched and searched. I have found piecemeal information.

I am going nuts trying to pass data across a pair of xbee S6.

I can get them to 'connect', but can not get data from one to the other. Using XCTU terminal console for the two units - nother appears on the other.

AI is 0 on both
CH is 1 on both
LM is FF on both

With "active scan" I can see each other and then select them.

Thank you in advance
asked Jun 8 in IEEE 802.11 (Wi-Fi) by AlanDewey New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The XBee S6B WIFI module does not support Peer to peer communications. It does support Point to point, Point to multi-point once the device is associated with either a Router or if using ISB Creator or Soft AP modes.
answered 1 day ago by mvut Veteran of the Digi Community (14,338 points)
...