Remember
Register
Home
/
Support
/
Support Forum
/
Xbee3 reset to default values
Digi Forum
All Activity
Q&A
Questions
Hot!
Unanswered
Tags
Categories
Users
Ask a Question
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.
All categories
Digi Remote Manager
(383)
Python
(1,016)
RF Solutions and XBee
(8,414)
Device Cloud-enabled RF Gateways
(97)
XBee3
(475)
IEEE 802.11 (Wi-Fi)
(267)
IEEE 802.15.4
(1,644)
ZigBee PRO Featureset (and legacy ZNet 2.5)
(1,488)
ZigBee Smart Energy Profile 1.1
(111)
DigiMesh Proprietary Mesh Networking
(782)
Multipoint Proprietary
(197)
XLR PRO
(17)
XStream
(40)
XTend
(137)
XCite
(4)
XPress
(8)
Miscellaneous Hardware and Software
(513)
XBee Programmable Development
(777)
XBee Cellular
(119)
MicroPython
(66)
Digi TransPort
(786)
Digi Connect Cellular
(444)
DAL
(4)
Embedded Devices
(4,160)
Google Coral
(2)
Rabbit
(3,194)
Console Servers
(353)
Modbus and Industrial Automation
(246)
Realport
(600)
Serial Servers
(836)
Satellite Modules
(25)
USB
(1,269)
Serial Cards
(715)
ConnectPort Display
(58)
Feedback/Wish List
(92)
Other/Legacy
(373)
Xbee3 reset to default values
0
votes
I have a XBEE3 module in 802.15.4 mode and sometime the module resets to its defaults parameters.
I interface the module to uP using UART in transparent mode.
In firmware I don't enter in command mode, i think is impossible that the module receive the ATRE command.
There is some hardware possibility to reset the module?
Thank's
Daniele
xbee3
reset
factory-defaults
asked
Jun 14, 2021
in
RF Solutions and XBee
by
danieleGR
New to the Community
(
0
points)
Please
log in
or
register
to add a comment.
Please
log in
or
register
to answer this question.
1 Answer
0
votes
Daniele, No, it does not have a hardware restore function but it does have a reset line that if triggered would power cycle the radio. So if your settings are not written to flash, that would restore it to default settings.
answered
Jun 21, 2021
by
mvut
Veteran of the Digi Community
(
15,108
points)
Please
log in
or
register
to add a comment.
...