Home/Support/Support Forum/HUBPORT 7C causes devices to fail FW upgrade via Segger JLINK
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

HUBPORT 7C causes devices to fail FW upgrade via Segger JLINK

0 votes

We have just purchased a HUBPORT 7C with power supply. To this we have connected a NRF58240 eval board. But when we want to flash this board with JLINK (Segger) it fails. It works without the hub and it works with other hubs.

Kind regards,

HW info:
Manufacturer Model SystemType
LENOVO 11DUS1UJ01 x64-based PC

OS info:
Caption CSDVersion OSArchitecture Version
Microsoft Windows 10 Enterprise 64-bit 10.0.17763
asked Jul 14, 2021 in USB by cuwittrock New to the Community (0 points)
It is not only when updating a connected device via JLINK but also devices that resets. Devices that are reset seems also to be blocked by the hub. The port simply gets disabled.
I hope that someone can provide some assistance. This is the most expensive hub we have bought, but it has the worst performance we have experienced.

Please log in or register to answer this question.