Timeout, Stalled waiting for proper response

Question

Hi all,

I have used XBee S2C PRO module, while updating the firmware using X-CTU, I have got the Timeout, Stalled waiting for proper response error. Does any body have faced similar kind of problem? How to fix that problem? Any guidance is much appreciable.

Answer 1

Sounds like your module is configured for sleep modes. Try setting the radio to defaults and try it again.

Comments

Hi @mvut,

Thank you for the response, the problem occurs with my new PC, but there was no such problem with the same radio with another PC.

---

You can try reloading the drivers and optimizing them.

Answer 2

How is the XBee attached to your computer? Sometimes you need to double check your COM port settings, like Flow Control. They can cause odd problems like that.

Comments

Hi @Plater,

Thank you for your comment.
However, I have double cross-checked the com. port & settings (Baud-9600, Flow Conrol- NONE, Data Bits-8, Parity- NONE, Stop Bits-1). Which are same as of my previous PC. I have suspected the driver of the programmer but while setting the parameters and doing the range test from another XCTU it works fine.