It seems that I have a serial device that doesn't agree with my Edgeport/4 COM ports. Over time that device will become "disconnected". If I run the Confidence Test (using digital/internal loopback) that port shows up as "failed". The solution so far has been to change ports, but eventually that port fails the Confidence Test as well...it's as if this serial device is killing the Edgeport/4 ports one at a time.
My question is...is there some way to "reset" or "refresh" the Edgeport/4 to get these COM ports back? Clearly I seem to have a problem client device but I would hope that I don't lose an Edgeport/4 along the way as well...