Home/Support/Support Forum/backup source rabbit 3315
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

backup source rabbit 3315

0 votes
I would like to backup my rabbit 3315, I no longer have the source code. Could someone describe me in detail how to do it?thanks
asked 5 days ago in Rabbit by fazumbo New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
There is a program that extracts the entire flash content or just the firmware. This is available at Digi's website under 9.62A release. You can find the latest release below;
https://hub.digi.com/support/products/dynamic-c/?path=/support/asset/dynamic-c-962a-new-release/

Is also available on Dynamic C 9.62 github, https://hub.digi.com/support/products/dynamic-c/?path=/support/asset/dcrabbit-9-on-github/.

The program runs in ram and does a dump of the flash or firmware in the device, whichever you specify. So you should NOT compile it to flash because it will erase whatever is in flash, it will need to be compiled to RAM.

You will need a programming cable part# 20-101-1183 to extract the flash and Dynamic C programming environment. Your module will need to be connected to a development board or your own hardware. Follow the instructions provided in the extract_flash program located in the following path once you install Dynamic C's development environment; C:\DCRABBIT_9.62A\Samples\extract_flash.c
answered 5 days ago by Campbell Veteran of the Digi Community (834 points)
...