Home/Support/Support Forum/XBee 3 file transfer

XBee 3 file transfer

0 votes

I want to send a file using xbee 3 also want to receive it on xbee3 means sending via xbee3 to another xbee3, working on a semiconductor project.
By using ATFS get and put at instructions is it attainable? While using following command I tried to transfer file but I didn’t receive instead got timeout error.
Can you suggest me how can I transfer file with ymodem protocol and also get file through above mentioned protocol?

asked Oct 26, 2021 in RF Solutions and XBee by EllieNora New to the Community (0 points)
edited Feb 27 by EllieNora

Please log in or register to answer this question.

1 Answer

0 votes
You are not able to transfer a file from the file system over the RF port to another XBee modules file system using the ATFS commands.

You would need to pull the file to an external processor via the UART first, then send the file over the RF port from the external processor to a remote external processor. Then put it back again on the remote modules file system.
answered Oct 26, 2021 by mvut Veteran of the Digi Community (15,110 points)