Home/Support/Support Forum/Digimesh ATDN local reply 0x88 status

Digimesh ATDN local reply 0x88 status

0 votes
USing XCTU with Digimesh
Sending the ATDN discovery node message with target node string I receive
AT Command Response (API 1)

7E 00 0F 88 01 44 4E 40 FF FE 00 13 A2 00 41 6B 99 01 AC

Start delimiter: 7E
Length: 00 0F (15)
Frame type: 88 (AT Command Response)
Frame ID: 01 (1)
AT Command: 44 4E (DN)
Status: 40 (Status OK)
Response: FF FE 00 13 A2 00 41 6B 99 01
Checksum: AC

Status: 40 (Status OK)
But in frame 0x88 description Status values are 0 1 2 3 only
asked Nov 19 in DigiMesh Proprietary Mesh Networking by accacca New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
That is a I would suggest submitting a case with Digi Support by sending an email to tech.support@digi.com. When doing that, make sure you include the Digi part number for the XBee you are working with and the firmware version.
answered Nov 19 by mvut Veteran of the Digi Community (14,777 points)