Home/Support/Support Forum/AT Command - Number of Children?

AT Command - Number of Children?

0 votes

I am using xbee3's with digimesh. I have some nodes that are always on and act as repeaters for other sleeping nodes. Is there an AT Command I can use to figure out how many nodes are using the repeater? I would like to be able to track this as a part of the repeater health metric over time to see if it is being used by the network or not.

Thank you.
asked Dec 3, 2021 in XBee3 by backpacker87 Community Contributor (51 points)

Please log in or register to answer this question.