Home/Support/Support Forum/How do I send a reset command via an XStick device using python?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How do I send a reset command via an XStick device using python?

0 votes
I have a device that exposes data via an XStick.

The interface is a crude serial at 115200 baud from which I can poll 120 bytes of data.

However, from time to time it gets itself into a state.

And the only way to clear this state is to remove the XStick from linux box, insert into a PC or Mac, and run the vendor's software - after which the data starts to flow again.

Obviously the vendor's proprietary software is doing something - but I am not sure what.

I guess I could try and setup some serial tunnelling and check, but in the hope of a simpler approach, I message the forum.

If there was an escape sequence/reset command I could use via the serial line, that would be good to know!

Thanks
asked Dec 22, 2021 in Python by nzfarmer New to the Community (5 points)

Please log in or register to answer this question.

1 Answer

0 votes
What software are you referring to that you are running?
answered Dec 28, 2021 by mvut Veteran of the Digi Community (15,112 points)
...