Home/Support/Support Forum/how to pin wake up for xbee3

how to pin wake up for xbee3

0 votes
Hi, everyone.
Can you teach how to pin-wake up by micropython.
my xbee3 status is SM = MicroPython Sleep,D1 = Digital Input,D8 = sleep/DTR
I read those pages(https://www.digi.com/resources/documentation/digidocs/90002219/reference/r_sleep_mp.htm?TocPath=Power%20management%20with%20MicroPython%7C_____2 , https://github.com/digidotcom/xbee-micropython/blob/master/samples/power_management/set_sleep/main.py)

I checked input pin value(0,1) in D1. So, I did the same sensor inserted DIO8.
And,I used sample(set_sleep). But,xbee3 didn't wake up early.

In addction, I read "If timeout_ms is None then pin_wake must be set to True and the device will sleep indefinitely until a falling edge on DIO8 occurs.". Is this interpretation "x.sleep_now(True)"?

I thank you in advance for your reply.
asked Dec 22, 2021 in XBee3 ZigBee by qwerty New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
The directions in the manual say to use SM=0 and then in your code to use the XBee().sleep_now() and XBee().wake_reason() to control the modules wake and sleep functions.
answered Dec 30, 2021 by mvut Veteran of the Digi Community (15,223 points)
I use XBee3 module. So, I was setting SM = 6.
setting SM=0 is correct when using XBee cellular module.
And so, my xbee is endless sleeping. I can't change program and can't doing pinwake up.
Use the Commissioning button to restore the module to defaults by pressing it four times within 1 second.
...